Hw-module Slot R0 Reload
- Hw-module Slot R0 Reloadable
- Hw-module Slot R0 Reloading
- Hw-module Slot R0 Reloader
- Hw-module Slot R0 Reloaded
service single-slot-reload-enable redundancy no keepalive-enable mode sso And it doesn't seem to ever sync the slave Try adding: hw-module slot 2 image slot0:/rsp-k4pv-mz.120-32.S8.bin hw-module slot 3 image slot0:/rsp-k4pv-mz.120-32.S8.bin slave auto-sync config And then (make sure to wr mem first): hw-module standby-cpu reset. Reload: Reloads the operating system for the entire device Note: For the Nexus 7000, this command works only in the default VDC.! 6500 hw-module module slot reset! 4500 no hw-module slot module number power hw-module slot module number power. Reload module mod-# Reloads a module in the device by turning power off then on. All points it is a false positive as once checking the status of the Superport we can see it as 'up', example: Switch# sh platform hardware interface all b Superport60 Superport60(Gi10/25-30) Hardware Mac State Superport Mac Link State: Up Conditions: - 4510 chassis with SUP8-E and WS-X4748-UPOE+E inserted into slot 10 - switch configured to.
I have a test 7507 with rsp-k4pv-mz.120-32.S8.bin on both RSP2s. I've done
this:
service single-slot-reload-enable
redundancy
Hw-module Slot R0 Reloadable
no keepalive-enablemode sso
And it doesn't seem to ever sync the slave
ranttest#show red
Redundant System Information :
------------------------------
Available system uptime = 14 minutes, 49 seconds
Switchovers system experienced = 0
Standby failures = 0
Last switchover reason = none
Hardware Mode = Duplex
Configured Redundancy Mode = sso
Operating Redundancy Mode = hsa
Maintenance Mode = Disabled
Communications = Down Reason: Simplex mode
Current Processor Information :
-------------------------------
Active Location = slot 2
Current Software state = ACTIVE
Uptime in current state = 13 minutes, 24 seconds
Image Version = Cisco Internetwork Operating System
Software
IOS (tm) RSP Software (RSP-K4PV-M), Version 12.0(32)S8, RELEASE SOFTWARE
(fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2007 by cisco Systems, Inc.
Compiled Mon 20-Aug-07 16:34 by leccese
BOOT =
Hw-module Slot R0 Reloading
CONFIG_FILE =BOOTLDR =
Configuration register = 0x2102
Peer (slot: 3) information is not available because it is in 'DISABLED'
state
ranttest#redundancy force-switchover
Hw-module Slot R0 Reloader
Cannot perform switchover until the standby is fully initialized.
The box is up, its got two OSPF adjacencies, maybe a hundred routes - its
not doing anything fancy, so I'm kind of stuck here. The production target
is 7507s /w RSP4s, the same OSPF, and about 180k routes via BGP. Any idea
what might be wrong here?
Hw-module Slot R0 Reloaded
_______________________________________________
cisco-nsp mailing list cisco-nsp@puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/